Designing a keyboard in Fusion 360
Speed run by BeardFromFargo designing a keyboard in Fusion 360.
KBD.newsPublished May 14, 2021
Creators! Feel free to
tip me off about your keyboard related projects to bring them to 100K readers.
3D printed end result: https://imgur.com/a/1SsEMKa
The design of this 3D printable keyboard was made IRL in under 60 minutes in Fusion 360:
Published on Fri 14th May 2021. Featured in KBD #26 (source).
Related
Zack Freedman talks about his
MiRage Mk2, an ortho split with eInk display.
Wojciech Baranowski's
Viosuo is an arm-strapped keyboard for standing work.
Great video tutorial by
Reda0202 on making a
custom wireless keyboard with Attiny + nRF + Arduino (
source).
Momoka FROG Linear switch review by
Reimu64 (
video).
A custom 3D-printed
unibody split keyboard by
justsunone – with video tour.
This time
riskable put an
IR receiver into his keyboard (
video).