Keyboard Builders' Digest / Tips & Tricks
Sofle case
A Sofle RGB case designed and shared by u/drudge007.
Published July 30, 2022
This is a case for the Sofle RGB. It has a solid top plate and a shine-through bottom. The bottom piece attaches with 5 x M2 5mm screws. Once screwed in, put sticky feet on the circular pads and you're good to go.
I made my own case for my Sofle RGB in Fusion360. Why? I wasn't thrilled with the cases available, so I set out to make my own […] – drudge007.
The case was designed with the following in mind:
- no screws inserted/visible from the top
- a solid top piece so no seams or gaps are visible either
- shine-through bottom because of the underglow LEDs
I wanted the underglow LEDs to actually shine-through, so the bottom plate would have to be really minimal – drudge007.
Resources
Files on Thingiverse: https://www.thingiverse.com/thing:5444009
The top plate was used from here: https://www.thingiverse.com/thing:5245688/files
Published on Sat 30th Jul 2022. Featured in KBD #89 (source).
Did you like reading this post?
Related
Batreeq
Batreeq: A 30-key pseudosplit keyboard by AlSaMoMo – with a trackball and scroll ring.
Carved case 2
A gorgeous wooden keyboard case by Breakwood with meticulously carved and gold plated solid copper insets.
Rock On v3
Rock On v3 by Sadek Baroudi. With case STLs.
Travel case for Sofle
Travel case for Sofle by gianni777 with STL files.
Jonkey
Jonkey is an open-source split by u/SmashedTatoes, designed via ergogen.